Multiple Sclerosis (MS) Support Group

This community is a place where members can discuss current events and weigh in on what's going on in the world.

0 Online

mmthlvr 02/06/2015

I've been having this problem more & more lately & wondered if anyone else has this issue. When injecting it goes in very slow or stops altogether, the only thing I can do is pull it out & then it sprays everywhere, Any advice would be great.

littlemart 02/07/2015

I used to have that happen. Call Shared Solutions and they will replace your injector.

HCARD 02/07/2015

Same here they sent me a new one asap.

mmthlvr 02/08/2015

Thanks, I will call them tomorrow.
Hugs
Tammy

brianap 02/09/2015

I experienced this as well. I eventually went to doing the shots manually and found it to be a lot easier. It was way gentler than the autoject.

GeminiAmy 02/16/2015

Been on it for 4 years never had that happen good luck to you plz let us know how it goes.

mteverest 02/19/2015

I had my injector replaced twice. But another thing I noticed was that when I inject onto hard firm lumpy spots from previous injections, then the medicine doesn't go as fast so I just have to hold for a minute or two for it to go thru.

Now I have to make sure the area is clear of previous lumps before injecting.

Shared solution even will send the replacements for all the wasted copaxones as well.

GeminiAmy 02/23/2015

This just happen to me! If it does it again I will call and get a replacement :(

GeminiAmy 02/25/2015

Just asked for a new auto injection SB here in a week:)

Join the Conversation