WTP movie
Drinking water transfer printing films encompass a transparent layer of polyvinyl alcohol (PVA), that is printed having a variety of decorations. The ink layer is then sealed. The PVA layer dissolves on speak to with h2o. Thereafter, the seal is dissolved by an activator (a particular sort of solvent) and only the color layer stays. The paint layer adheres for the workpiece immersed and behaves similar to a lacquer layer after drying.
The ideal h2o temperature for the process of printing water films is 32 ° C. In cold climate up to 34 ° Celsius.
The transfer drinking water transfer movie must be lower on all sides in a length of one cm to forestall winding when inserting about the floor from the drinking water. Please usually do not stay with tape since the film cannot rise during the immersion process (In the event the PVA is dissolved, the movie "relaxes" along with the area measurement raises minimally).
After the specified publicity time, spray the film in a length of 20-30 cm in the route of crossover with activator of twenty five to forty five g / m² (with regards to the explanation, because highly printed movies need to have far more activator).
The workpiece can be immersed after approx. fifteen seconds.
All factors which can be not made of Ab muscles plastic ought to be well prepared ahead of diving (eg by lacquering).
After approx. One particular moment, the workpiece should be washed with scorching water at 42 ° C (do not make use of a robust h2o jet, elements of the movie may dissolve).
The coloration shown may possibly vary through the authentic movie depending on the output system. For the consequence that's akin to the image, the color advice history need to match the chosen water transfer print movie.
The ideal h2o temperature for the process of printing water films is 32 ° C. In cold climate up to 34 ° Celsius.
The transfer drinking water transfer movie must be lower on all sides in a length of one cm to forestall winding when inserting about the floor from the drinking water. Please usually do not stay with tape since the film cannot rise during the immersion process (In the event the PVA is dissolved, the movie "relaxes" along with the area measurement raises minimally).
After the specified publicity time, spray the film in a length of 20-30 cm in the route of crossover with activator of twenty five to forty five g / m² (with regards to the explanation, because highly printed movies need to have far more activator).
The workpiece can be immersed after approx. fifteen seconds.
All factors which can be not made of Ab muscles plastic ought to be well prepared ahead of diving (eg by lacquering).
After approx. One particular moment, the workpiece should be washed with scorching water at 42 ° C (do not make use of a robust h2o jet, elements of the movie may dissolve).
The coloration shown may possibly vary through the authentic movie depending on the output system. For the consequence that's akin to the image, the color advice history need to match the chosen water transfer print movie.
Examine out this internet site: http://cursopinturahidrografica-wtp.com
Replies