Some Reasons Why You Have A Wet Spot On The Floor By Your Hot Water Heater.

Water heaters seldom fail and are known to last for years. They are relatively simple devices, with few components to cause trouble. However, water heaters will begin to fail with age. Given their low cost of replacement and our need for hot water, they are inexpensive appliances. If your water heater isn't working as well as it has in the past, you may want to troubleshoot it by looking at those components most likely to fail.If you discover a wet spot on the floor below a water heater, it is likely to have an impending failure. A puddle of water can only come from a few places. It's possible that the water heater's thermostat is leaking, or internal corrosion is causing a leak.Possibly the T&PR valve, which releases overheated water is leaking. The Temperature and Pressure Relief valve releases overheated water if the thermostat fails. At temperatures above the valve's limits, hot water is allowed to flow out the discharge pipe. A leaking tank is the next logical choice.One way to check the water temperature is with a thermometer. The water temperature shouldn't exceed boiling. A safe setting for hot water http://storify.com/daffyalman624/one-of-the-most-profitable-businesses-to-own - http://storify.com/daffyalman624/one-of-the-most-profitable-businesses-to-own - is 120 degrees F. The T&PR valve won't open and cause a water leak at this low temperature.If the T&PR valve passes all checks, you should next check the tank for leaks at the bottom. After discovering where the leak is coming from, your tank may require replacing. Consider buying the most energy efficient model you can afford.Gas water heaters have a temperature control set-up which could be the source of trouble, as well. A thermocouple are used to control both the water heater's pilot light and the water 's temperature. An indication of a bad thermocouple is too little or too cold water for the setting. You can replace the thermocouple to fix this problem.If you have an electric hot water heater, you have to consider the heating elements and the thermostat. Most electrical units have an top and bottom heating element. Either one of these can be a source of trouble. It isn't difficult to remove and replace a thermostat if need be. Thermostats control the unit's water temperature and do not usually fail. Because of the electrical hazard, you should consider consulting a qualified plumbing service technician to do this job.This article presented a fundamental guide to troubleshooting gas or electric water heaters. Without a lot of complicated features, water heaters are fairly easy to work on, although they can pose several serious safety hazards. Hazards around gas and electric hot water heaters include electrical shock, scalding and fire. Unless you are http://proudelection7105.wordpress.com/2014/06/04/home-improvement-website-design-ideas-pictures-remodel-and-decor/ - http://proudelection7105.wordpress.com/2014/06/04/home-improvement-website-design-ideas-pictures-remodel-and-decor/ - comfortable working around these hazards, consider calling a qualified service technician to service your heater.I recommend reading some of the other articles shared on PracticalRepairs.com for more insightful and practical home repair tips. By: Hunter MayArticle Directory: http://www.articledashboard.comHunter May is a freelance writer with years of home ownership, property management and home repair article writing experience. His articles are featured at PracticalRepairs.com and are focused on how anyone can make their own Practical Home Repairs. Looking for Home Repair Tips? Whatever your home repair problem is your can discover the best http://thrillingmusings.yolasite.com/thrillingmusings - http://thrillingmusings.yolasite.com/thrillingmusings - home repair tips at www.practicalrepairs.com