Home Improvement :: Using An Ozone Generator In Mold Remediation
Mold remediation is an important step towards getting rid of deadly mold in homes and other infested buildings. It begins with fixing the water and humidity problems besetting the affected area, and then followed by killing the mold and physically removing their remains. It is vital that mold remediation is done completely and thoroughly, or else the mold infesting the building http://www.doh.wa.gov/CommunityandEnvironment/Contaminants/Mold - http://www.doh.wa.gov/CommunityandEnvironment/Contaminants/Mold - will only grow back.Mold is at best a health hazard. In most cases, mold can be toxic and deadly. There are many diseases associated with mold, such as fungal infections, asthma and many forms of allergies. Mold causes harm when it comes in contact with bare skin or when it is breathed in. There have been a number of instances wherein mold infection has been proven to be fatal.There are a number of ways to get rid of mold in homes and other infested buildings. One such method is through the use of an ozone generator. In mold remediation, ozone generators make use of what is called "high ozone shock treatment." If molds are toxic, so is ozone. In high concentrations and for long exposures, ozone is capable of killing mold. Ozone can also remove the bad-smelling odors coming from the toxic fumes emitted by mold. The use of an ozone generator is a fast and cost-effective method of getting rid of mold.However, factors do exist which can limit just how effective an ozone generator can be when it comes to killing mold. The first factor is the size of the affected area, and the second factor is the level of mold contamination. If the size of the affected area is big, using a bigger ozone generator is necessary. The same goes with the level of mold contamination in the area; the worse the degree of mold contamination in an area is, the bigger the ozone generator needed is, the longer the required ozone exposure is, and the higher the ozone concentration should be.In mold remediation using an ozone generator, there are three important things that should be done in the process of ridding the contaminated area of mold. First is that the area to be treated should be unoccupied. No person, pet or plant should come inside the area to be decontaminated from mold. Just as ozone is toxic to mold, so it is toxic to humans, plants and animals.Second is that the air in the decontaminated area should be purified after the high ozone shock treatment has been completed and before the humans, pets and plants that formerly occupy the area come back to use it once again. Purifying the air after the high ozone shock treatment will get rid of the smell of mold; it will also make it breathable.Lastly, dead https://www.facebook.com/OdorKlenz/posts/10154417975678646 - remove mildew odors - mold should be vacuumed out and rid of. Mold can feed on dead mold; if the dead mold is not removed, it will be certain that the problem will recur. Mold remediation should be complete and thorough so mold contamination will not happen again.