Brother TN360 Toner Installation Guidelines and Tricks

So you have just unwrapped a TN-360 toner your bought a handful of months back, to replace your printer's cartridge which is now blinking empty. Soon after diligently following the manufacturer's installation instructions, you notice that the LED light on your Brother Laser http://blog.meritline.com/2015/12/23/ultimate-guide-to-brother-tn360-toner-tips-trick-to-reset-refill-and-specification/ - tn360 guide - Printer's manage http://www.overstock.com/Office-Supplies/Inkjet-Cartridges/12444/subcat.html - http://www.overstock.com/Office-Supplies/Inkjet-Cartridges/12444/subcat.html - panel continues to flash. Then you comprehend that it's 12midnight, and you happen to be rendered practically helpless, as you have completely no clue how to acquire a replacement toner in order to print an 80 web page report that is due first thing in the morning.
When such instances happen, a single may well instinctively call a technician for diagnosis, or buy a new toner to replace what is presumably a faulty cartridge. Whilst these problems are not uncommon, it's very good to know that most of these troubles can be rectified with out possessing to consult a specialist. Whether you've purchased a genuine toner or an aftermarket cartridge, here's a list of troubleshooting instructions for some TN-360 installation concerns:
1. Your printer's LED light blinks continuously even after replacing the TN-360 toner and DR-360 drum.
There will be certain cases when you could require to manually reset your printer to get rid of a blinking LED drum light. First, you will have to open your printer's front cover. With your new drum and toner nonetheless installed, press the go button or the white button. Hold for about 4 seconds until your printer's complete handle panel lights up. Close the front cover and your printer should now be ready for use.
2. Your newly replaced laser toner cartridge is prematurely showing as empty
If your printer's manage panel indicates an empty cartridge and you are almost particular (based on earlier prints) that your toner is nowhere near empty, this easy trick need to enable you to extend your toner's mileage. Begin by pulling out your cartridge from your printer. You should see two holes at both side of your toner. Use an electrical tape to cover each holes and reinsert your toner cartridge. You should be able to print a handful of hundred a lot more pages and save dollars without having getting to replace your TN-360 toner.
three. Flashing Error Light
A flashing error light can be one of the easiest but often also the most difficult of errors to troubleshoot. If you have just installed a new TN-360 cartridge, there may possibly be a need to clear your printer's memory which by now is very possibly full. Reset your printer by pressing the go button and holding it for around 5 seconds. Turn your printer off and on to verify.
If the error persists, verify for any paper jam. Inspect both the front and back panels. Don't overlook to pull out the DR-360 drum. Most paper jams take place in the drum and rear panel locations. Torn label and tape can trigger significant errors and are typically challenging to detect so make positive your printer is clear of any debris.
These are simple troubleshooting suggestions that will support you diagnose or fix some problems which you may have with your toner or printer. If you continue to experience problems, do not attempt to explore any additional as this may possibly trigger additional harm. When in doubt, do not hesitate to call a certified printer technician.